telnet to check cpu

Discussion in 'Cisco/Linksys Network Storage Devices' started by spoonernash, Jan 1, 2007.

  1. spoonernash

    spoonernash LI Guru Member

    I just purchased two slugs, which were packaged differently:

    slug1: no ntfs/fat32 sticker on box, made in Taiwan, came with f/w 24

    slug2: ntfs/fat32 sticker on box, made in China, came with f/w 63

    Initial objective - determine stock cpu speed, 133 v. 266.

    Searching located ourtelnetrescueuser information and slugpass.c code. Compiled slugpass and determined password for slug1. Turned on telnet, connected to slug1 and cat /proc/cpuinfo indicated 133 cpu.

    On slug2, I downgraded the f/w to 24 so I could attempt same procedure. Re-compiled slugpass.c for slug2 and got password of "paS0/LCQdAZLk". Note the "/" in the password. Turned on telnet and attempted login. Password is not accepted by slug2.

    What do you think about the "/" in the password? Do I need to enter it in a special way? Do you think the slugpass.c code doesn't work with slug2?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice