1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Testing RT-AC68U with or without tomato

Discussion in 'Tomato Firmware' started by oldassgamers, May 5, 2014.

  1. oldassgamers

    oldassgamers Connected Client Member

    Hello guys, I'm not sure if I did it correct.

    I had tomato installed and it worked great. I decided to use asus utility tool to flash back to asus original firmwire. After that I did nvram by clicking on the WPS button and holding it before I started up the router and couple of more seconds while it was active until it start blinking (about 30 seconds). Now im back on asus firmwire (the shit software woohoo :p ).

    Then I decided to go back to tomato and successfully flashed it back and used nvram in the tomato settings options.

    So my question is , did I do the "proper" way of going from tomato firmwire to asus own firmwire? Or How would have you do it?
     

Share This Page