1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

TinyPEAP with a client that uses Cisco ADU

Discussion in 'TinyPEAP Firmware' started by qwakui, Feb 21, 2006.

  1. qwakui

    qwakui Network Guru Member

    I have TinyPEAP set up on my Linksys WRT54G. It works fine when the client is using the Windows Wireless Configuration wizard, but when the client is using the Cisco Aironet Desktop Utility, version 2.6 (hardware is a Cisco CB21AG), it says Authentication Failed on the client. Has anyone gotten TinyPEAP to work with the ADU client, or proven that it won't work?
  2. qwakui

    qwakui Network Guru Member

    I have it working now. I got by creating the certificates and downloading them from the router. Then I installed the CA and connected without ADU enabled. I got a prompt again about accepting the certificate. I accepted that, then switched back to using ADU, and it connected without any problems.
    So to answer my question, you can use TinyPEAP with ADU 2.6 for Cisco CB21AG.

Share This Page