tomato client mode - how to forward upnp request to wan port?

Discussion in 'Tomato Firmware' started by rs232, Apr 19, 2012.

  1. rs232

    rs232 Network Guru Member

    LAN2 --(Tomato2)--> LAN1 --(Tomato1)--> Internet

    Hi all, I have a set of laptops connected to a LAN2 via a tomato in wireless mode. This subnet is a different IP subnet compare to LAN 1 and tomato2 does the routing/natting.
    So far so good, but how can I make tomato forwarding upnp request from LAN2 to LAN1?

    In my understanding as it is now tomato will accept a port request from a client in LAN2 and map the port on it's WAN, but Tomato1 would not receive any upnp request from tomato1.

    Considering tomato2 is in client mode I would have though this would work.

    Any input?

    Thanks :)
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice