Tomato DHCP not working after setup

Discussion in 'Tomato Firmware' started by IcyTexx, Jun 15, 2014.

  1. IcyTexx

    IcyTexx Networkin' Nut Member

    Hi...

    First of all, I'm loving Tomato!
    But after first setup and making it work with my FTTH (requires VLAN ID 100 on WAN) I ran into some problems. I've been at it for hours and can't solve it.
    I have setup Tomato after install as shown in thumbnails below. However, DHCP on LAN ports doesn't work. Nothing connected to 1-4LAN ports doesn't work.
    What do I need to change to make it work?
    DHCP over wireless works and Internet works.

    [​IMG] [​IMG] [​IMG] [​IMG]
     
  2. IcyTexx

    IcyTexx Networkin' Nut Member

    Yup... Just soft bricked it (and restored via serial) because I forgot to set up wireless before rebooting. Manual IP settings and everything else didn't work.
    Changing VLANs changes turns off DHCP, it must be something trivial I'm missing.

    EDIT:
    Problem seems to be resolved. I needed to change the VLAN ID from 97 to 1.
     
    Last edited: Jun 16, 2014
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice