1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Tomato for WRT120N needed

Discussion in 'Tomato Firmware' started by feliza, Nov 5, 2012.

  1. feliza

    feliza Serious Server Member

    Hello,

    please i have two wrt120n routers please can i get the tomato firmware for it?
     
  2. GhaladReam

    GhaladReam Network Guru Member

    You'll never see Tomato for this model. This router has an atheros chipset, and only 2MB flash. You might be lucky if you can get DD-WRT on it, but not much else. You'll need to get Tomato-supported models.
     
  3. ghoffman

    ghoffman Addicted to LI Member

    dd-wrt requires 4mb on atheros chip routers. the 2mb dd-wrt micro builds are only for broadcom.
    i did a little searching around for non-linksys routers with the same architexture as the wrt120n, hoping for better firmware - but came up empty-handed.
    i have found the wrt120n unstable with high load after a few days in AP mode. i conclude that either the platform is inherently unstable or the firmware was never good enough - and i think it's a dead-end. i wish it were otherwise.
     

Share This Page