Tomato running wireless ethernet bridge + AP possible?

Discussion in 'Tomato Firmware' started by ytyang, Mar 5, 2008.

  1. ytyang

    ytyang Network Guru Member

    My 2nd router used to run Tomato in wireless ethernet bridge and getting
    pretty decent wireless throughput with my gateway router running Tomato.

    I recently switched to DD-WRT v24 running repeater bridge mode to support
    wireless client. It works fine except the wireless throughput is about 10%
    less than before.

    Is it possible to enable AP function via init command while
    running in ethernet bridge mode?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice