Tomatousb for Netgear WNDR4000 N750 ?

Discussion in 'Tomato Firmware' started by duprade, Feb 12, 2013.

  1. duprade

    duprade Serious Server Member

    Hello everyone. I was wondering if it would be possible to have TomatoUSB for the Netgear WNDR4000 N750?

    I read somewhere that DD-WRT exists for this router, which I've never used but after researching and actually using Tomato, I currently use Shibby's build on my Asus RT-N16 and I'd prefer to stick with Tomato.

    CPU1: Broadcom BCM4718A1 (480 MHz)
    FLA1: 8 MB (Macronix MX25L6445)
    RAM1: 64 MB (Winbond W9751G6JB)​
    Expansion IF types: USB 2.0
    USB ports: 1​
    WI1 chip1: Broadcom BCM4718A1
    WI1 802dot11 protocols: bgn
    WI1 MIMO status: 2x2:2
    WI1 antenna connector: U.FL
    WI2 chip1: Broadcom BCM4331
    WI2 802dot11 protocols: an
    WI2 MIMO status: 3x3:3
    WI2 antenna connector: U.FL​
    ETH chip1: Broadcom BCM4718A1
    Switch: Broadcom BCM53115
    LAN speed: 10/100/1000
    LAN ports: 4
    WAN ports: 1​
  2. lefty

    lefty Networkin' Nut Member

    I too have wondered if support could be added for this unit, i have read somewhat positive reviews about the unit, also to add this is an nvram 64k unit.
  3. eahm

    eahm LI Guru Member

  4. distantcoder

    distantcoder Network Guru Member

    Yeppp.. Been waiting for this one for about 2 years now.. May be better off dumping the router and going for something that is supported..

    I have mine in the closet, some day I will use it for something.. Can't even use mine with factory firmware.. It sucks THAT bad...
  5. eahm

    eahm LI Guru Member

    Well, NETGEAR sucks, why did you get one in the first place?
  6. duprade

    duprade Serious Server Member

    That's the router at my parents house. After updating my RT-N16 to Tomato and seeing how useful a router can actually be, I wanted to upgrade theirs so I could setup VPN, among other things.
  7. distantcoder

    distantcoder Network Guru Member

    At the time, I thought it was the fastest Dual band router available. I have played with it a few times, debated trying to get the tool chain together on a dev box, but health issues and age don't have me as fresh as I used to be :p I'm an old assembler programmer, gone rogue to design work, so a bit too busy with family and tryin to make a buck. As far as getting it.. I totally take credit for being an idiot.. lol
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice