1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Toolchain to build voipong?

Discussion in 'Tomato Firmware' started by brunes, Sep 26, 2007.

  1. brunes

    brunes LI Guru Member

    Hello. I am not sure if this belongs in the Tomato forum, but since that is the firmware I am running I will post it here.

    I was wondering if anyone can help me with some kind of general instructions for building a binary to run under the tomcato firmware. I want to build a version of voipong ( http://www.enderunix.org/voipong/ ). This app sniffs the wire and decodes and saves all SIP traffic as wav files.

    My desire is to build a version of this to run on my WRT54G and save the wav files to a mounted SMB share.

    I do not know at this point if the router will be able to handle the CPU load, or even what the CPU load would be. This is because I can't figure out how to get a compiled and working version of the thing. I built a complete FreewRT toolchain on my desktop, but when I copy the built static binary over it does not run successfully. I assume this is because of some kind of difference between tomato and FreeWRT.
     
  2. roadkill

    roadkill Super Moderator Staff Member Member

    Tomato is using the Linksys official toolchain/kernel which is pretty old, you need to compile it under that toolchain or it will not function correctly...
     
  3. brunes

    brunes LI Guru Member

    Where can I get that toolchain?
     
  4. roadkill

    roadkill Super Moderator Staff Member Member

  5. BassKozz

    BassKozz Network Guru Member

    I am by no means and expert around here but after taking a quick look at VOIPong's site I found this:
    And considering that WRT's only have only 200Mhz processor (version 2.0 and above), I doubt this will work?
     
  6. roadkill

    roadkill Super Moderator Staff Member Member

    Mips processors perform differently you should try maybe you'll get a bearable result...
     

Share This Page