Trouble with Gateway settings for PPPOE on E3000 using DD-WRT

Discussion in 'DD-WRT Firmware' started by Manzaboy, May 7, 2013.

  1. Manzaboy

    Manzaboy Reformed Router Member

    Hi,
    I am using a Linksys E3000 with DD-WRT installed (dd-wrt.v24-15962_NEWD-2_K2.6_big)and wanted to configure it to be a Gateway in use with a TP-Link TD-8817 ADSL modem in Bridge mode.

    I have changed the IP address of the Modem to 192.168.2.1 and have set the modem into Bridge mode with DHCP switched off.

    I have then set up the E3000 as a Gateway in PPPOE mode with DHCP enabled.
    I have however not been able to get the E3000 to connect.
    I suspect the issue is with the DD-WRT Network setup configuration?

    My settings are;

    Local IP: 192.168.1.1
    Subnet: 255, 255, 255,0
    Gateway: 192.168.2.1
    Local DNS: 192.168.2.1

    It shows as disconnected in the WAN status.
    I am in the UK and using SKY broadband.

    Screenshots of relevant screens on post here [​IMG]


    http://www.dd-wrt.com/phpBB2/viewtopic.php?t=171624&sid=b6addad0e00dbc79ee2c824452ae439d


    Has anyone got a configuration like this working or can suggest where I might be going wrong? I have trawled through various posts but not found an answer...



    Many thanks in advance,

    Manzaboy



     
  2. Kevin Darbyshire-Bryant

    Kevin Darbyshire-Bryant Networkin' Nut Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice