1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

trying to configure my WAP54G

Discussion in 'Other Linksys Equipment' started by calimove, May 12, 2008.

  1. calimove

    calimove LI Guru Member

    equipment:

    WAP54g
    grid antenna on roof (believe 24db gain)

    software

    v3.04

    At this point i have the system very simple. Grid antenna on roof. Found open network(arbys across the street). I pointed that way and did a site survey too see my signal strength. I am at about 63%. I do not recall if this is enough too connect. What all config settings do i need too have set in order to make work. I have all settings at default right now. Once i read the site survey i copy the mac addy and select wireless repeater mode. I will then put in the MAC addy there and save changes. This is the only setting i configured. What else do i need too do to get this working?

    thanks
     

Share This Page