1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

TUNNEL BUT NO DATA

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by MikeMc, Mar 2, 2006.

  1. MikeMc

    MikeMc Network Guru Member

    :sadbye:
    I need help. I have 2 rv016 VPN's that were working fine when one was hooked to a T1 without NAT and the other was hooked up to DSL. We just had a new line installed (not our choice) that orginates in a 192.168.1.0 subnet and is sent down to us over ADTRAN 3200 T1 point to point boxes. We are being given an address of 10.19.7.3, with the gateway of 10.19.7.1. The Linksys box will create and establish the secure tunnel but now we cannot get any data to pass between the boxes. I mean no ping of the other boxes LAN and the other LAN cannot ping us, but both boxes show the tunnel is up.

    Linksys, Adtran and I are all stumped (ranks right up there with not being able to get this stupid QuickVPN to work).

    Only good news is that I can establish a PPTP connection with the other RV016 box and that is allowing us a small workaround but we need a fix.

    Mike
     
  2. TazUk

    TazUk Network Guru Member

    So what are the IP addresses of the various bits?
     

Share This Page