1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Turn of WAN light

Discussion in 'Tomato Firmware' started by Low-WRT, Dec 23, 2009.

  1. Low-WRT

    Low-WRT LI Guru Member

    I believe this has been discussed before...I'm just apparently not a good searcher.

    Is it possible to turn of the WAN(Internet) light on the front of my WRT54GL?
    I have cable internet and my router picks up outside line traffic.
    Basically, the light is annoying. I know I can put tape on it, but I'd like to turn it off, if possible.
    Thank you.
  2. Low-WRT

    Low-WRT LI Guru Member

    After further review, it looks like it's not available to turn off.

    # led
    led <wlan/diag/white/amber/dmz> <on/off> [...]
  3. pfoomer

    pfoomer LI Guru Member

    led white off
    led amber off

    Does that work?
  4. landa

    landa LI Guru Member

    Only the leds below can be turned on & off

    Pin Direction Name Use
    GPIO 0 Output WLAN LED (LED - wireless)
    GPIO 1 Output POWER LED (LED - power)
    GPIO 2 Output ADM_EECS (LED - white, Cisco button v. 3.0+)
    GPIO 3 Output ADM_EESK (LED - amber, Cisco button v. 3.0+)
    GPIO 7 Output DMZ LED (LED - DMZ)

    The script for this (not tested):

    #This is the LED to hack
        $gpio disable $led

Share This Page