I have two WRT54G that I upgraded to Alchemy and I am trying to set them up on my home network. WRT#1-IP 184.108.40.206 is connected to my DSL and is setup to assign addresses (starting at .20) to my Lan (my desktop work great to the internet) this one is in the basement. WRT#2-IP 220.127.116.11 ( DHCP disabled and WRT#1 is its gateway) is connected by cable to WRT#1 from Lan port one. From My desktop I can get to both. Both also have WPA/PSK with the same key and both have the same SSID (for Roaming). With the my wifes tablet I am able to connect but it seems that I am connecting to WRT#1 which is the fartest or I get the message limited connectivity so it seems that if I do connect to WRT#2 I cannot get an address. WRT#1 is set to Gateway and WRT#2 is set to router. What is the correct way to set up two WRT54s so I can go any place on my property and connect?