1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Unable to install tomato on buffalo WHR-G54S

Discussion in 'Tomato Firmware' started by rs232, Sep 19, 2009.

  1. rs232

    rs232 Network Guru Member

    This is probably my 5th installation on Buffalo WRT devices.
    I've never experienced any problem flashing the firmware from the original one to tomato before.
    Basically what happens is that the whr_install.bat script is not working properly.
    The router is booting up with the old firmware all the times.
    I did set the IP of the LAN on 192.168.11.2/24
    I did reset the default settings on the router, I did try to unplug/plug the power different times to help the script to kick in at the right moment... but no luck!

    Is there any other way to flash the firmware?

    I can access the original web console but I'm not sure I can flash the firmare with tomato from here.

    Any help advice would be much appreciated!

    Thanks
    rs232
     
  2. rs232

    rs232 Network Guru Member

  3. rs232

    rs232 Network Guru Member

    Leaving wireshark open on the ethernet port this is the capture for the first 30 seconds of the router booting up.

    [​IMG]

    This is the only packet sent by the router:
    115 31.137757 192.168.11.1 239.255.255.250 SSDP NOTIFY * HTTP/1.1

    SSDP?
     

Share This Page