Unbrick WRT54G v1.0

Discussion in 'Cisco/Linksys Wireless Routers' started by AlphaQ, May 8, 2005.

  1. AlphaQ

    AlphaQ Network Guru Member

    Is it possible to unbrick a v1.0 WRT54G? I'm looking at the guide and trying to do this and it is a lot different than then v1.1 guide. I believe I located the flash chip but there are no numbered pins or anything of the sort.
     
  2. AlphaQ

    AlphaQ Network Guru Member

    I located my flash and it appears to be an AMD called AM29LV320DB or something like that. Basically when I turn on my router I have a solid Power LED and a DIAG LED that won't turn off. None of the other LEDs work when I "reset" or plug in things. Is my router completely dead? Or is this just bricked?
     
  3. Toxic

    Toxic Administrator Staff Member

  4. Guyfromhe

    Guyfromhe Network Guru Member

    I don't think that guide covers v1.0s though, and if the lan/switch LEDs asren't comming on in this case thats exactly what I had an i had NO luck debricking that... I ended up replacing it... pretty much until you can make it link a port you can't do anything.. most of them don't brick this hard... what did you do to i?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice