Unsuccessful inter-VLAN routing RVL200

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by jmcafee, Apr 27, 2011.

  1. jmcafee

    jmcafee Addicted to LI Member

    I cannot get packets to route between VLANs despite being enabled.

    I've rebooted, reloaded default configuration, started fresh and set up VLANs without any other configuration.

    Firmware 1.1.12.1 (problem since much earlier versions). Subnets enabled. Each port is set up for Access/Untagged. Both VLANs checked on the Inter-VLAN Routing page.

    Devices in each VLAN see the WAN, but not the other VLAN (determined by ping).

    What am I doing wrong?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice