Upgrade of firmware went bad for RVL200

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by wgramlich, May 3, 2009.

  1. wgramlich

    wgramlich Addicted to LI Member

    I upgraded my RVL200 to the latest firmware v1.1.10.1

    The DIAG light just flashes :help:
    The DHCP is not working. I am able to ping the router 192.168.1.1.
    Unable to pull up the router page via web browser.

    I hit the reset button a few times and even held the reset button for over 30 seconds, the lights never flash like it reset. I even hit the reset button while powering it on. This seems to flash some lights. But it still does not work.
    :help:
     
  2. I have the same issue. Did you ever get it sorted?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice