1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

upgrade satori WRT54G and crash- How recover?

Discussion in 'Sveasoft Firmware' started by sergey, Oct 18, 2004.

  1. sergey

    sergey Guest

    When I was upgrading my WRT54G with satori, upgrade crash, so now WRT54G doesnt init.

    Boot_init was not activated!

    I heard something about upgrade jumping the flash memory...

    Anyone know something about?

    Thanks in advance

    SeRgEY
     
  2. zaphod

    zaphod Network Guru Member

    hi,

    try to search for "fried" or "flash" in this forum...

    you will find what you want..


    greets
     
  3. Morpheus

    Morpheus Network Guru Member

    download ftp://ftp.linksys.com/pub/network/wrt54gv2_2.04.4_US_code.exe

    this is an autoupdater.

    then connect your trashed WRT54G.

    run autoupdater and enter IP and pwd etc. but dont click on upgrade.

    then power on WRT54G and at the same time click on Upgrade (within a second or so. this should do the trick. if not the shorting of the pins WILL work if you do it correctly.

    ie short 15-16 at same time as you power up the router.

    this then goes into flash mode. use the sequence before this one to upgrade again.
     

Share This Page