Use QoS only when certain traffic exists?

Discussion in 'Tomato Firmware' started by Mango, Dec 23, 2012.

  1. Mango

    Mango LI Guru Member

    Is it possible to classify bulk traffic differently, depending on if any traffic that requires high priority is active? We would like bulk traffic to run completely unrestricted, when no high priority traffic exists.

    Currently we have set our Outbound and Inbound Max Bandwidth to 66%/80% of our actual speed. Sometimes our ISP runs slower than it should, so we want to be conservative.

    The best I've done so far is a script with an endless loop inspecting /proc/net/ip_conntrack, and running service qos stop/start appropriately. Though this worked, it was too expensive for my liking.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice