Using Cisco button to toggle pppoe accounts

Discussion in 'Tomato Firmware' started by QSxx, Dec 9, 2007.

  1. QSxx

    QSxx LI Guru Member

    Here's one for all scripters out there:

    I have two pppoe accounts - one is "limited" to 1 GB of traffic and other is "flatrate" (unlimited traffic).

    What i would like to have is a script, that i would put in cisco button section, that would disconnect pppoe if active, swap uname/pass, and then reconnect (optionally light white led when flat (second) account is in use)

    Hope it aint too difficult - some poking around nvram should be fun :biggrin:

    Cheers
     
  2. QSxx

    QSxx LI Guru Member

    noone, eh?

    come on guys, or should i put it to tomato wishlist?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice