Victek - see no IP on eth1

Discussion in 'Tomato Firmware' started by mealto, Apr 25, 2014.

  1. mealto

    mealto LI Guru Member

    I am now running Victek on an E4200 and Bandwidth Limiter works so buttery smooth. As I am diggign around, I see 1 eth1 device in the device list that has no IP. I see TX/RX going on and off. eth1 is my 2.4 antenna.

    Over the last hour, this device does not have an IP. But it has signal stregnth and quality. Doing a MAC address look up tells me it's a Cisco-Linksys LLC MAC address. Could this be the antenna on the router itself? So odd.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice