1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

VOIP ATA Won't Register with 1.13

Discussion in 'Tomato Firmware' started by schweinc, Dec 7, 2007.

  1. schweinc

    schweinc Network Guru Member

    Greetings,

    For the first time since using Tomato I've run into a problem. As soon as I upgraded to 1.13 my Zoom ATA would not register. The ATA receives a static IP and is connected directly to my GSv4. Played around with the Firewall NAT Loopback Enable/Forward but no improvement. Reloaded 1.11 and all is well.

    Anyone with ideas?

    Thanks and Happy Holidays,

    PIG
     
  2. njeske

    njeske Network Guru Member

    i have a linksys ATA that is registered just fine with 1.13. not sure how to help your problem, just wanted to post that mine is working just in case that helps anyone with figuring this out.
     
  3. JensG

    JensG Network Guru Member

  4. schweinc

    schweinc Network Guru Member

    JensG,

    Yes I did recycle power to my Zoom 5801 but to no avail. Weird. I'll try 1.13 again and see if maybe the VOIP company was having a problem at the same time I uploaded.

    Judging from your and njeske's post it looks like it's my problem.

    Thanks,

    PIG
     
  5. LLigetfa

    LLigetfa LI Guru Member

    Does it have a battery that may need to be pulled for a full reset?
     
  6. ljohnson15

    ljohnson15 LI Guru Member

    I also have a Zoom 5801 and Linksys PAP2 and no issues after 1.13 upgrade.
     
  7. schweinc

    schweinc Network Guru Member

    Fixed

    TO ALL,

    Thanks for the advice. Reloaded v1.13 and all is well. Looks like maybe the service provider was having an issue the same time as loading new firmware.

    All is well now.

    PiG
     

Share This Page