vpn cant connect

Discussion in 'Tomato Firmware' started by JDavis, Nov 4, 2009.

  1. JDavis

    JDavis Guest

    hello guys, tomato newbie here ;)
    need some help to start the vpn

    i'm configuring a client vpn via WRT54GL
    protocol: UDP
    firewall: auto
    authorization mode: TLS
    HMAC: disabled
    compression:enable
    checked creat NAT on tunnel
    checked DNS configuration
    checked redirect internet traffic
    inserted CA, client cert &key

    just wondering, any other configuration that i need to check/configure?
    right now, i cant seem to start the vpn

    pls help
     
  2. groosh

    groosh Addicted to LI Member



    I have made a couple of replies in the following thread... not sure if it will help or not but, maybe.

    http://www.linksysinfo.org/forums/showthread.php?t=63197
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice