VPN Routing WAG54G + WRV200 + RV042

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by chobott, Nov 17, 2007.

  1. chobott

    chobott Network Guru Member

    Hello

    i have this network situation:
    1x RV042
    2x WAG54G
    6x WRV200
    1x Cisco 875

    EndPoint is RV042, in main office, any other is small office
    At now i have on RV042 all VPN connection

    From point A i can ping to B, C, D and E
    I need ping from E to C for example
    or from D to B and other

    At now i must set VPN between A-B, B-C, B-D.........

    We using VoIP and i need call from E to C etc....

    Thank you for help.....
     

    Attached Files:

  2. DocLarge

    DocLarge Super Moderator Staff Member Member

    It looks like you have a "hub and spoke" set up.

    Depending on whether or not router A supports "hair pinning (allowing router "B" to ping router "C" via way of router "A") your configuration would work. If not, then you may need to establish a tunnel between "each" router to ensure full connectivity, which would be better as far as redundancy goes. In your present configuration, if router A goes down, vpn communication between all segments are gone...

    Jay
     
  3. chobott

    chobott Network Guru Member

    Vpn

    Yes, but my second problem.....
    for example main router RV042 and 5 small router WRV200 are in one City, and i have connectivity from local provider, all this router are under provider NAT, and others routers are outside provider NAT, but i can set only ONE VPN with NAT-T
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice