WAG200G ArpTable ?

Discussion in 'Other Linksys Equipment' started by morkrom, Mar 22, 2007.

  1. morkrom

    morkrom LI Guru Member

    I need to access from remote to my pc only some time. Instead my pc is always on because WOL is blocked by my WAG200G
    I've tryed a lot of solutions but without success: (inside my LAN WOL is ok)
    -subnetting 255.255.255.128 so the broadcast is 127 and not 255;
    - forwarding to 192.168.1.127 (broadcast) the magic packet from internet via NAT.
    I think the problem is in Arp Table (a closed PC have only MAC Address , no IP) but I can't make static Row in arp table (the firmware 1.01.01 not have arp command)

    Can someone help me?

    Thanks in advance

    MR
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice