1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

wag200g connection problem: Couldn't get channel number: Transport endpoint is not connected

Discussion in 'Other Linksys Equipment' started by snoxu, Mar 29, 2007.

  1. snoxu

    snoxu LI Guru Member

    My wag200g has been running pretty much rock solid, except every now and then it doesn't connect to my ISP.

    The internet led stays red and this is an excert of the log when I can not connect to my ISP:

    This is the log when it connects to my ISP without problems:

    ATM running FW version 1.01.03. I'm a bit stumped wondering why this is happening
  2. snoxu

    snoxu LI Guru Member

    *bump anyone
  3. HiSpeed

    HiSpeed Network Guru Member

    Try 1.00.09 or 1.00.05 instead !
  4. snoxu

    snoxu LI Guru Member

    There's no 1.00.03 as far as I know

    I'm running 1.01.03 at the moment.

    How will I know if 1.00.09 is going to do any good. I only have this problem every know and then, it doesn't happen often and I can't detect any kind of pattern. When it does happen I usually have to stop using the router for 6 hours maybe more in order to be able to connect to my ISP using the wag200g. During this time I'm able to connect to my ISP using a usb Speedtouch 330 modem. So my best guess is something goes out of wack in the wag200g.

    Can someone in here interpret the system log for me and tell me what's happening?
  5. HiSpeed

    HiSpeed Network Guru Member

    Sorry, I was referring to the initial release 1.00.05 (I modified my post)...

Share This Page