WAG300n and problems with Cisco VPN client solved

Discussion in 'Other Linksys Equipment' started by sharkeytoo, May 16, 2008.

  1. sharkeytoo

    sharkeytoo LI Guru Member


    I had a problem using the WAG300N and Cisco VPN Client 4.6.3

    I could establish the connection and get allocated an ip address within th evpn network but couldn't telent or ping to any host within the network.

    If I rebooted the WAG I coulld connect the vpn and get it working again but only for the first attmept, after that it would stop working again on subsequent VPN attempts.

    I used Linksys live chat and they sent me a link to verison 1.1.7 (03) beat firmware and now its working ok. I haven't removed any of the port forwards I put on to try to get it working before the upgrade but my start to remove them one by one.

    Just thought I'd share the info.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice