1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAG54G-UK Annexe A to Annexe B? DSL Issue

Discussion in 'Other Linksys Equipment' started by alanwhite, Feb 11, 2005.

  1. alanwhite

    alanwhite Network Guru Member

    Hello

    I bought this unit in the UK but I live in the Czech Republic. When plugged in etc the units DSL light does not light up and the setup software says that the line is down. he line works fine with my normal USB ADSL moem.

    I wondered whether this was becase it was a UK unit and, if so, if there was anything could do to sort it? I have seen a web site in the Czech Republic selling this unit and it says "Annexe B". Could this be the issue and, if so, could I refloash this Annexe A unit with Annexe B without frying it??!!

    Any help will be very much apreciated!

    Regards
    Alan
     
  2. HiSpeed

    HiSpeed Network Guru Member

    Annex A is ADSL over baseband POTS.
    Annex B is ADSL over ISDN.
    Annex C is ADSL over japanese ISDN.

    At start, DSL led is flashing when trying to synchronize and lighting when synchronization is OK.

    VC settings (VPI, VCI and Multiplexing) are used for synchronization !
     
  3. alanwhite

    alanwhite Network Guru Member

    Hi

    I appreciate the response but, presuming that the Czech Republic is ADSL over SIDN (and I need to check this), the question is, if I were to reflash the bx as Annexe B after it has vcome as Annexe A will that in any way damage the unit or should this be fine?

    Alan
     

Share This Page