WAG54G - using a pool of public IP addresses

Discussion in 'Other Linksys Equipment' started by Anonymous, Jul 13, 2005.

  1. Anonymous

    Anonymous Guest

    Everyone knows about this?

    If I received a pool of public IP address by the ISP and I want
    to use these IPs for Indipendent connection of clients to Internet
    how I need to set the WAG54G gateway?

    I mean:

    I tried to:

    1) disable NAT and DHCP feature from basic setup webpage
    2) assign the public IPs, SN MASK, Gateway, DNS values to
    the clients NICs
    3) set the linksys device IP (its WAN interface) and gateway
    according to ISP supplied values.

    Performing these three steps it's not possible to exit on Internet from the
    clients device using the public IP's. Do you know why?
    Anyone know links or references where I can look deeply to overcame
    this problem?

    Many thanks.

    Fiction.
     
  2. geeza

    geeza Guest

    I'm trying to do this as well. I tried the iptables guide using Alchemy but couldn't get it working..
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice