WAG54G V1.2 and ipv6 tunnels

Discussion in 'Other Linksys Equipment' started by xpromache, May 18, 2005.

  1. xpromache

    xpromache Network Guru Member


    Has any of you managed to set up an ipv6 tunnel through an wag54g V1.2 adsl router?
    Normally it should work if you set up the internal computer as "DMZ" but for me it does not. I disabled the firewall on the router, still I get no ipv6 packet. I have the impression that the damn router just drops the protocol 41 (ipv6 over ipv4) packets.
    Does anybody know if I can monitor somehow the packets as they traverse the ADSL interface?

  2. xpromache

    xpromache Network Guru Member

    After few hours of debugging I managed to get it working.
    The trick is to configure the internal computer (the one set as DMZ) with the external IP (in addition to the internal IP).
    For some reason the stupid router sends arp requests only on the ethernet ports not on the wireless. So you have to initiate a connection from inside to outside first.
    If somebody wants more information, please contact me directly.

  3. Ofloo

    Ofloo Network Guru Member

    i have a wag54g v2 .. did you use any special firmware ?
  4. babanetcom

    babanetcom Network Guru Member

    I'm very interested in v6 support..I sent xpromache a pm but I had no answer (his last join was in june). Could anyone help me?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice