1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAG54G & WET54G Problems

Discussion in 'Other Linksys Equipment' started by vidpix, Sep 28, 2005.

  1. vidpix

    vidpix Guest

    Hi everyone,

    I am in the process of setting up a wired/wireless network as follows;

    Office 1
    WAG54G 192.168.1.1 Wired to Switch
    Linksys 8 Port Switch
    Desktop Pc 192.168.1.2 Wired to Switch
    Desktop Pc 192.168.1.3 Wired to Switch
    Desktop Pc 192.168.1.4 Wired to Switch
    Laptop Pc 192.168.1.5 Wired to Switch
    Laptop Pc 192.168.1.6 Wired to Switch
    Laptop Pc 192.168.1.7 Wired to Switch
    Laptop Pc 192.168.1.8 Wired to Switch
    WET54G 192.168.1.200 Wired to WAG54G

    Office 2
    Linksys 8 Port Switch
    WET54G 192.168.1.202 Wired to Switch
    Desktop Pc 192.168.1.40 Wired to Switch
    Laptop Pc 192.168.1.50 Wired to Switch

    Repeater Site
    WET54G 192.168.1.201 Standalone

    Each of the WET54G's are on the roof of each building Office 1 and the Repeater Site will have 15Db Omni Aerials,Office 2 will have a 14Db Directional Aerial pointing at the Repeater Site. The reason for the repeater site is that there is not a direct line of sight from Office 1 to Office 2, but the Repeater site is close to Office 1.

    I have configured each of the units as above, however, if when I connect each of the WET54G's to the switch,I get an 'IPconflict' Error message

    If I plug the WET54G directly into a laptop or desktop I dont get the error message. and can connect (via wireless) to the machine to see the drives.

    I have configured the gateway of each computer to 192.168.1.1 (the WAG54G). is this what is causing the problem ??

    Also I want to use WPA PSK - Once I have set the key on the WAG54G and each of the WET54G's is everything done automatically or do I have to reset the key at the predetermined time interval as set on the WAG54G config screen, I did notice that in the config screen for the WET54G there is a re-authenticate button.

    The WAG54G is set for NO DHCP and for some unknown reason, it doesn't show any attached computers via the config screen whether wireless or wired

    Any help would be appreciated

    Thanks


    Mark
     

Share This Page