1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAN address in device list, show GW

Discussion in 'Tomato Firmware' started by kthaddock, Jul 24, 2013.

  1. kthaddock

    kthaddock Network Guru Member

    In "Status" => "Device list" => "IP addres" show gateway instead of wan-ip isp's ipnumber.
    Maby that is my config cause that but what do you guy's have there ?
    I'm using Shibby 110-ND-AIO

    kthaddock
     
  2. koitsu

    koitsu Network Guru Member

    This is correct behaviour. Status -> Device List shows you IP addresses that are "seen" across an interface, not the IP address associated with the interface itself. It's more akin to listing off ARP traffic than it is anything else. Proof (only MAC addresses modified below):

    Code:
    root@gw:/tmp/home/root# ifconfig vlan2
    vlan2      Link encap:Ethernet  HWaddr 10:BF:XXX:6A
               inet addr:76.102.14.35  Bcast:76.102.15.255  Mask:255.255.252.0
               UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
               RX packets:85831538 errors:0 dropped:0 overruns:0 frame:0
               TX packets:40541799 errors:0 dropped:0 overruns:0 carrier:0
               collisions:0 txqueuelen:0
               RX bytes:2490553970 (2.3 GiB)  TX bytes:3879764094 (3.6 GiB)
    
    root@gw:/tmp/home/root# ifconfig br0
    br0        Link encap:Ethernet  HWaddr 10:BF:XXX:69
               inet addr:192.168.1.1  Bcast:192.168.1.255  Mask:255.255.255.0
               UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
               RX packets:41564199 errors:0 dropped:0 overruns:0 frame:0
               TX packets:57171767 errors:0 dropped:0 overruns:0 carrier:0
               collisions:0 txqueuelen:0
               RX bytes:3295390420 (3.0 GiB)  TX bytes:1591668235 (1.4 GiB)
     
    root@gw:/tmp/home/root# arp -a
    ? (192.168.1.51) at 00:30:XXX [ether]  on br0
    ? (192.168.1.50) at 90:2B:XXX [ether]  on br0
    c-76-102-12-1.hsd1.ca.comcast.net (76.102.12.1) at 00:01:XXX [ether]  on vlan2
    
     

    Attached Files:

  3. kthaddock

    kthaddock Network Guru Member

    Okey Koitsu
    I have looked at my settings like you and I have same but I have more units on network.
    I thought I should read "real" wan Ip and not gateway.

    Thank you
    kthaddock
     
  4. Monk E. Boy

    Monk E. Boy Network Guru Member

    Depends on what interface is showing the internal (e.g. 192.168.x.x) address. If it's showing the internal address as being assigned to vlan2, at least for Koitsu's configuration (and mine) then that's obviously incorrect information. If it's showing br0 (again given the same configuration) as having that address, then Device Status would be correct.
     

Share This Page