1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP/PSK plus MAC filtering. Possible?

Discussion in 'Other Linksys Equipment' started by Biker, Feb 11, 2005.

  1. Biker

    Biker Network Guru Member

    Hi,

    I have a brand new AP, WAP54G Firmware Version 2.08.

    I have set it up with WAP/PSK. Everything works fine. In this mode, I can connect with a LINKSYS Wireless-G PCI Adapter WMP54G all right.

    But, if I also enable MAC filtering, I can't connect any more.

    "Enable", plus "Permit PCs listed below to access the wireless network" plus the correct MAC address in the first field.

    There are two of us looking at that MAC address in the AP. There are two of us looking at the output from IPCONFIG in Windows. They are the same.

    Shouldn't it be possible to use MAC address filtering with WAP/PSK ?

    Biker
     

Share This Page