1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP11 as a Client :wallbang:

Discussion in 'Other Linksys Equipment' started by r6dude, Feb 12, 2006.

  1. r6dude

    r6dude Network Guru Member

    Folks,

    I have a WAP11 with DWL 900AP+ firmware on it. What I would like to is connect to a FreedomLink network using the WAP11 in client more and then connect WRT54G to the WAP11.

    So the Setup is:

    PC => WRT54G(Alchemy) => WAP11(900AP+) =>FreedomLink

    What I am having trouble is to setup WAP11 as a client. I correctly set the WAP11 to connect to FreedomLink hotspot. But I am confused in terms of connecting my PC to WAP11 to check whether I can reach the Internet.

    Question:
    1. What should be the IP address of the LAN port on WAP11 when the WAP11 is in Client mode?
    2. How should the PC be set in term of getting a IP address?

    Thank you.

    Aj
     

Share This Page