1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP11 Web Access to Config

Discussion in 'Other Linksys Equipment' started by Condorian, Aug 13, 2005.

  1. Condorian

    Condorian Network Guru Member

    I have a WAP11 with a USB port that I bought from a friend.
    I managed to reset to defaults via the USB and it now works fine after setting up the WEP, SSID etc.

    However I can't access the web based config.
    The WAP is using 192.168.1.51 and typing http://192.168.1.51 into either IE or Firefox just reults in a time out.

    I can ping it:
    C:\>ping 192.168.1.51

    Pinging 192.168.1.51 with 32 bytes of data:

    Reply from 192.168.1.51: bytes=32 time<1ms TTL=64
    Reply from 192.168.1.51: bytes=32 time<1ms TTL=64
    Reply from 192.168.1.51: bytes=32 time<1ms TTL=64
    Reply from 192.168.1.51: bytes=32 time<1ms TTL=64

    Ping statistics for 192.168.1.51:
    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
    Approximate round trip times in milli-seconds:
    Minimum = 0ms, Maximum = 0ms, Average = 0ms

    I cannot get telnet access:
    C:\>telnet 192.168.1.51 80
    Connecting To 192.168.1.51...Could not open connection to the host, on port 80:
    Connect failed

    C:\>telnet 192.168.1.51 81
    Connecting To 192.168.1.51...Could not open connection to the host, on port 81:
    Connect failed

    The WAP11 is connected to a 4-port switch that's part of my broadband modem/router (a Vigor 2600). 2 other PC's are connected to this router via the switch.
    My laptop is picking up the wireless connection and browsing, e-mailing, IRC etc without issue. All the wired PC's browse, e-mail etc. with no issue. All can access the router config just by typing http://192.168.1.1 so there's no issue with proxies or anything similar (it's all direct connection, there is no proxy).

    The WAP is on firmware v 1.4i.1, I'd like to upgrade but can't unless I get access to the config!

    Anyone got any ideas?
    Seen this before?

    Thanks in advance,
    Mike
     
  2. Condorian

    Condorian Network Guru Member

    Solved.
    Finally discovered that the older of the two doesn't have a web interface.

    You live and learn.
    Both AP's now work fine in AP mode.
    Having some trouble getting either to work as an AP Client, but I'll do some more work before posting about that.

    Thanks,
    Mike
     

Share This Page