1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP54G and MAC Acces time

Discussion in 'Other Linksys Equipment' started by tiben26, Jun 11, 2007.

  1. tiben26

    tiben26 Guest

    Hi,

    I have a network running with around 15 WAP54G v1.1 linksys wireless access points. I am all ready using the MAC filtering function, via the router web GUI. I want something to allow me to select the time each Mac addresses is allowed to connect. Some can be 2 months and others more. I was told i have to use a captive portal software. I also tried flashing dd-wrt, which was not stable at all on these low ram access points. I would get a connection reset every couple minutes so I upgraded to the latest version, only to completely brick the access point. Do u guys know of any software that could perhaps run with the linksys firmware, do I have any other better options??

    Thx

    Ben
     

Share This Page