1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP54G client TO WAP54GE

Discussion in 'Other Linksys Equipment' started by lu1fmo, Apr 11, 2007.

  1. lu1fmo

    lu1fmo Guest

    I want to buy 3 Access point WAP54G and 1 WAP54GE ( the external ).If i put the 3 wap54g`s in client mode, can i connect to the wap54ge in mode AP? Because the manual of the wap54g says that only works in mode client connected to another wap54g. will work properly?
  2. fastpakr

    fastpakr Network Guru Member

    If I remember right, the client mode is only for point to point bridging. You can do what you want with DD-WRT loaded onto the WAP54G. For that matter, you can get WRT54GL's and load them with DD-WRT as well, doing the same job as the WAP54G for similar cost with better hardware. What's the cost on the WAP54GE? You may be able to duplicate that using your own materials for less money.

Share This Page