WAP54G dead!!

Discussion in 'General Discussion' started by bimbobo, Aug 11, 2005.

  1. bimbobo

    bimbobo Network Guru Member

    I have a WAP54G and I was trying to change the firmware to one of the 3rd party's.
    After some troubles to find the way to "downgrade it", I managed to do so, but after downgrading to the original from 2.08, the AP is now dead!
    I am still lucky to have my guarantee and that the firmware (1.9) is a Linksys one... The shop accepted to trade it for a new.
    I would like to know if there is somewhere in this forum or elsewhere a real good guide about changing the FW to another not Linksys from scratch and for newbie? Which firmware to choose, I am only interested in changing output... to a higher one, the rest is not important.
    I would also like to keep my WAP PSK ecryption.

    Could I change the trasmission power without change the FW? like tweaking something else??

  2. 4Access

    4Access Network Guru Member

    Have you seen the Installation page on the HyperWAP website?
  3. Tiva

    Tiva Network Guru Member

    Are you did the right way for installing FW ? what did you done ? there are a lot of people here that change their FW and had not any problem .

    ALso see http://www.seattlewireless.net/index.cgi/WAP54G
    for increasing the power without changing the FW !!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice