WAP54G <> Senao SCB-3220 400 Mw = Not working !

Discussion in 'MustDie Firmware' started by Darkvador, Jun 27, 2006.

  1. Darkvador

    Darkvador Network Guru Member

    Well , i had 3 wap with 3 Dlink 7Dbi Antenna , bridged to each other with a 29 % Signal and a speed of 8 Mbps Average and a ping of 2 .
    i wanted to Improve that Signal so i bought a Senao SCB-3220 with an Output power of 400 Mw , and i place it in the center of the two other , i had The Signal Strenght Increased to 52 % but i had a speed drop and after a 5 min of working the connection just dies ( 0 % Activities and speed ) ( every time ) !!! i read after then that the WAP54G COULD ONLY WORK with another one of his kind !!!!!!!
    what i wanted to know is that , If mustdie Firmware Could help making the two different devices work together ?
    thanks in advance :)
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice