1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP54G V1.1 bricked after dd-wrt.v24 install

Discussion in 'DD-WRT Firmware' started by kjohnson_eclypse, Jun 4, 2008.

  1. WAP54G V1.1 bricked after dd-wrt.v24-9517_VINT_micro.bin download. System version ID via serial number which starts "MDG1". Has PCI card inside. Symptom: reponds to ARP for with correct MAC address, but won't respond to ICMP Ping or browser or tftp, even after 30-30-30 second hard reset during on-off-on power cycle.

    Previously had been running Linksys 3.04 firmware, very poorly. (I found the Linksys website to be confusing -- I don't think the 3.04 works well on V1.1)

    So I recommend against installing either of those on a WAP54G V1.1.
  2. grantmc

    grantmc Guest

    I just tried the exact same thing. I have bricked my wap54g as well with dd-wrt v24. Any suggestions for unbricking?

Share This Page