1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP54g v2 - solid ACT led

Discussion in 'Other Linksys Equipment' started by intersys, Oct 25, 2005.

  1. intersys

    intersys Network Guru Member

    Just installed a new WAP54g with 4.2.07 stock firmware. The act led was solid green before even connecting with ethernet cable to a lan port on WRT54g. Remained solid green after connecting ethernet cable. Tried a reset...same result. Should I be returning the unit?

  2. xVZx

    xVZx Network Guru Member

    Sorry but are you sure about the firmware version of your WAP54G ?

    The latest one from the supplier is the 3.03....
  3. intersys

    intersys Network Guru Member

    My bad - firmware is Linksys release 2.08

Share This Page