WAP54G-WAP54G Bridge Throughput

Discussion in 'Other Linksys Equipment' started by smike, May 26, 2005.

  1. smike

    smike Network Guru Member

    I have 2 WAP54G v2 access points running the Linksys 2.08 firmware in bridge mode. I get decent performance out of this configuration, but I want to extend the range by boosting the power output on both devices. I have tried Freya, MustDie and HyperWAP. With all three of these alternate firmware releases, I get a reliable connection, but my throughput drops to about 1/25th of what I get with the same configuration on the manufacturer's firmware. Re-installing the Linksys firmware restores acceptable performance.

    Any ideas?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice