WAP54G >> WRT54G with WPA

Discussion in 'Cisco/Linksys Wireless Routers' started by pbary, May 5, 2005.

  1. pbary

    pbary Network Guru Member

    I have wired network in the basement and some wired nodes on the second floor of my house. I'm using a WAP54G in the basement to connect to a WRT54G upstairs where cable internet access originates. I'd like to switch from WEP to WPA but can't seem to get it working regardless of AP mode on the WAP54G. Can anyone confirm success in
    connecting these two units with WPA enabled?

  2. howardp6

    howardp6 Network Guru Member

    I have a WRT54Gv1 running HyperWRT 2.1b1 using WPA-PSK TKIP. I have a WAP54Gv2 in bridge mode, which is connected wireless to the WRT54Gv1.
  3. pbary

    pbary Network Guru Member


    thank you...apparently it can be done so I must be sideways somehow,,,

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice