1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WDS not connection to 2nd router

Discussion in 'Tomato Firmware' started by were55, Sep 22, 2010.

  1. were55

    were55 Addicted to LI Member

    Hi everyone,

    I have followed this thread for a long time, almost a couple of years, installing every new firmware released by TB and sometimes Victeck, with excellent results, but now I`m facing a new problem:

    My main router (R1 192.168.1.1) have the last TB (also I tested with Victeck) version 1.28 K2.4 build 50 in an ASUS 520GU, and I added a new ASUS 520GU (R2 192.168.1.15) in WDS mode, this is the configuration:

    R1
    AP+WDS 192.168.1.1 non-security, Ip range 192.168.1.100 to 149, etc
    R2
    AP+WDS 192.168.1.15 non-security, with a DVR connected in 192.168.1.11 address.

    I can access the DVR within LAN and WIFI, but the problem start when I tried to access from internet, I made several tests changing "port forwarding" in R1 (I used 8090 FW to 192.168.1.15) but I can`t connect, also I made some port forwarding in R2 (port 8090 FW to 192.168.1.11) with same results...any idea?

    I will appreciate any help

    Thanks in advanced
     
  2. Toastman

    Toastman Super Moderator Staff Member Member

    Do you have the default route / gateway on .15 set to 192.168.1.1 ?
     
  3. were55

    were55 Addicted to LI Member

    Hi Toastman,

    Yes, I have it....in fact, now is working fine, I have turned off both routers and after 20 seconds I turned on Router1 then 10 seconds later router2....Also, I had to add DVR and Router2 MACADDRESS to R1, now is working fine and I can access my DVR from internet...thank a lot anyway.

    Regards
     

Share This Page