1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WDS WRT54GL Tomato and WRT54GS DD-WRT micro??

Discussion in 'Tomato Firmware' started by apeffect, Mar 18, 2008.

  1. apeffect

    apeffect Network Guru Member

    I am fairly new to this. I have little complicated issue. Also have couple of questions I am looking answers for.

    Here is my setup

    Main router WRT54GL w/ Tomato 1.17 (hard wire to the Cable modem); AP + WDS; DHCP server; WEP

    2nd router WRT54GS v.5 w/ DD-WRT micro; AP; DHCP disabled; WEP

    I have WDS going on between the two routers. WDS seems to be working fine.

    I have different SSID ID names so I can pick which AP to connect. How do I setup my 2nd router so everyone connecting to it would actually get IP via DHCP from 1st router.(note: 2nd router has DHCP disabled) ????


    Questions:

    * Can I have two different networks of same subnet in WDS? With DHCP server on both router. If possible then how do I do it?
    Eg: WRT54GL network 192.168.1.16 subnet mask 255.255.255.240
    WRT54GS network 192.168.1.32 subnet mask 255.255.255.240

    * Can I have two different networks and different subnet in WDS? With DHCP server on both router. If possible then how do I do it?
    Eg: WRT54GL network 192.168.1.16 subnet mask 255.255.255.240
    WRT54GS network 192.168.10.94 subnet mask 255.255.255.224

    - Answers to above question will help me figure out which AP I am connected to at a time.


    * What ports does Xbox live traffic travel? Want to set QOS for it.


    More questions will come as I mess w/ this more.
     

Share This Page