WET-54g and Blinking power LED

Discussion in 'Other Linksys Equipment' started by amirali_esh, Dec 25, 2004.

  1. amirali_esh

    amirali_esh Network Guru Member

    Hi all,

    I have a WET-54g V1.1 with firmware 2.05. There was a strange problem with this device that cause the Power LED to start blinking and then the bridge stopped working. Reseting it doesn't helped. I upgraded the firmware to 2.06 which is supposed to fix this problem. However it just worked for 5 minutes and then again Power LED starts blinking and the bridge failed again. If I run the firmware upgrade again it will get fixed but it will fail after 5 minutes again. Could someone help me with this problem?


    Thnx
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice