1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WET mode using WPA2 on WLI-TX4-G54HP

Discussion in 'X-WRT - OpenWRT Firmware' started by LLigetfa, Dec 2, 2012.

  1. LLigetfa

    LLigetfa LI Guru Member

    I have not been on here in quite a while and when I was, I frequented the Tomato forum. I am trying to use WET mode with WPA2. I first tried with the latest Tomato on a Buffalo WHR-HP-G54 but found no joy. Later I tried OpenWRT on a WLI-TX4-G54HP and while I can get it to associate to the AP, I'm not finding the magic to bridge through to a LAN port.

    Anyone care to toss me some hints or maybe even adopt me as a pet project? I tried posting over on the OpenWRT forum but it has not gotten any answers.
    https://forum.openwrt.org/viewtopic.php?id=40820
     

Share This Page