WET54G v3 problem - Is any alternative available

Discussion in 'HyperWAP Firmware' started by tszyman1, Mar 17, 2006.

  1. tszyman1

    tszyman1 Network Guru Member

    Hi All,

    I wanted to ask if there is any alternative firmware to be installed on WET54G V3 bridge? I have may problems with this bridge and I'm looking for some alternative.

    TS
     
  2. pigpig

    pigpig Network Guru Member

  3. pigpig

    pigpig Network Guru Member

    I refer to the wap54g v3
     
  4. AirCooln

    AirCooln Network Guru Member

    Let me guess, WPA PSK encryption and lockups after a couple of days? WEP encryption and its fine?
     
  5. tszyman1

    tszyman1 Network Guru Member

    Exactly this is the problem but in my case it works only for a couple of minutes.
     
  6. Toxic

    Toxic Administrator Staff Member

    I have a beta filename: wet54gv3_2d04Beta8_us_20060519.img

    if thats any good? I'll put it up on the downloads in a minute.

    however This is the HyperWAP forum for WAPxxx hardware.
     
  7. Tremo

    Tremo LI Guru Member

    I went down to Staples and bought a new WET54G. It ended up being a V1. I'm using WPA-TKIP on the router so the WET wouldn't talk to it. POS. So I take it back for refund and drive over to Fry's and buy a Buffalo bridge. Cheaper than the WET by about 30 bux, supports WPA and works like a champ. No hangups or other problems at all. ONly issue is configuration is not nearly as easy as with a Linksys.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice