1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Wget

Discussion in 'HyperWRT Firmware' started by jplbulls, Feb 10, 2005.

  1. jplbulls

    jplbulls Network Guru Member

    When I run this script on alchemy it works, but not with HyperWRT, can anyone see if im doing something wrong?

    # nvram set rc_startup"wget http://xxxxkaid/kaid -O /tmp/kaid;wget http://xxxx/kaid/kaid.conf -O /tmp/kaid.conf;chmod +x /tmp/kaid;/tmp/kaid -d -d /tmp/kaid.conf;
    #nvram commit
    #reboot

    When I check /tmp after reboot, kaid nor kaid.conf are there.
     
  2. VenimK

    VenimK Network Guru Member

    Check your paths from where ya get your kaid & kaid.conf
     
  3. auslander

    auslander Network Guru Member

    Did you place that in the startup script, or just ran it once? If you want it ran automatically after a reboot, then it has to be in the startup script.
     

Share This Page